• SWWB-24V - Solenoid Starter Switch
  • SWWB-24V - Solenoid Starter Switch

SWWB-24V - Solenoid Starter Switch

Model : SWWB-24V

An idle starter solenoid can receive a large electric current from the car battery and a small electric current from the ignition switch. 

When the igenition switch is truned on, a small electric current is sent through the starter solenoid .

This cause the starter solenoid to close a pair of heavy contacts, 

thus relaying a large electric current through the starter motor, 

whcih in turn sets the engine in motion.


** 24V  3P

**Special Application: Universal

**Normally Open

**Circuitry: SPST

**Contact: Cooper

** Working Volt : max 30V

** Continuous Rating : 100A

**Maximum Current Make: 150A

**Intermittent TIme: 10 Sec On/20 Min Off

**Coil Resistance: 64+-2 Ohm
** Temperture Range : -30 - 80℃

If a starter solenoid receives insufficient power from the battery, it will fail to start the motor

and may produce a rapid clicking sound. The lack of power can be caused by a low battery, 

by corroded or loose connections in the battery cable, or by a damaged positive (red) cable from the battery. 

Any of these problems will result in some, but not enough, 

power being sent to the solenoid, which means that the solenoid will only begin to push the engagement gear, 

making the metallic click sound.


1114223 , 2257158 , 3635820 , 56131K , 88923249 , U1453 , SS584, 185807


185836 , 277609 , 3209066 , 3209201 , 378444 , SWX72 , SS584


DODGE B150 (1984-1985)


DODGE B250 (1984-1985)


DODGE B350 (1984-1985)